![]() When you remove the pintool, record the thickness on paper (hold your finger on the pintool when you remove it to display thickness). ![]() This mark is your "telltale" of where you will begin to carve the outside of your foot. From the inside of the pot, at the point where you have estimated the bottom meets the wall, push a pin tool straight through until it comes out the bottom. Just in the beginning, while first learning to trim, there is a trick one can use to "mark" where the foot should be placed. Remember how it is shaped, you may even want to draw a quick sketch.Ģ. It is very important to maintain as much consistency as possible in wall and bottom thickness.ġ. "S" cracks have several causes, one of which is an uneven thickness in the bottom of the pot. This is not a hard and fast rule foot placement can be personal and based on what is aesthetically pleasing.Ĥ. This juncture is where the outside of the foot will begin. A helpful guide for foot placement is to estimate where the bottom of the bowl meets the side walls. A good way to think of trimming is to imagine that you have created a bowl with a continuous shape and now you are "adding" a foot.ģ. ![]() Always trim the pot based on or following the inside shape.Ģ. You should be able to press a finger nail into the clay but it should be firm enough to be handled without damaging its shape.ġ. The pot should be "leather hard", that is it should be the consistency of chocolate or cheddar cheese.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |